4-in-1 dimmable LED driver: DALI, PUSH, TRIAC, 0/1-10V. 10W constant current
The SRP-TRIAC-10CC is a 10W ENEC approved TRIAC LED driver with a constant current output of 1 channel and adjustable current ranging from 200mA to 350mA via DIP switches, making it suitable for various LED lights.
The triac dimmer driver is designed with DALI, Push, Triac, 0/1-10V 4 dimming interfaces in 1, allowing it to work with different control systems. Input of 200-240V-AC. The LED driver adopts an amplitude dimming output instead of a PWM output to ensure there is no visible flicker.
The power factor of the LED driver can be greater than 0.9, and the efficiency is over 83%. It allows for smooth and deep dimming down to 1% without flickering or buzzing. 1 DALI address can be automatically assigned by the DALI masters.
Compatible with Tridonic software. App for users to control their individual luminaires via the Wi-Fi network.
The DALI regulation is specifically designed for smoothly dimmable LED lighting, with no jumps in dimming, no flicker, and no noise.
According to the IEC 62386-101, IEC 62386-102, and IEC 62386-207 standards, this DALI controller is compatible with most DALI systems on the market. The Triac dimming driver may be compatible with universal Triac dimmers. When selecting the 0/1-10V interface, it is compatible with universal 0/1-10V dimmers.
Main Features TRIAC Dimmable DALI PUSH 0/1-10V Regulator
- Dimmerable LED driver with DALI/Push+Triac+0/1-10V control interfaces
- 1 constant current output channel, maximum output power 10W
- Output current 200mA-350mA selectable by DIP switch
- Allows control of single-color LED lighting.
- Analog current control, no PWM output, no flicker.
- Class II power supply, fully insulated plastic case
- High power factor and efficiency
- Complies with IEC 62386-101, IEC 62386-102, IEC 62386-207 standards
- Compatible with universal DALI masters that support DT6 commands. With universal TRIAC dimmers. Compatible with universal 0/1-10V dimmers.
- IP20 protection rating, suitable for indoor LED lighting applications.
1. Selection of the regulation interface
1.1. The LED driver supports 4 types of dimming input: DALI, Push, Triac, 0/1-10V.
1.2. Select any of the 4 control interfaces to wire each time.
1.3. To connect a new dimming interface, the previously connected dimming interface must be disconnected.
1.4. Do not connect more than 2 control interfaces simultaneously.
2. DALI address assigned by the DALI masters.
While connecting to the DALI interface, 1 DALI address can be automatically assigned by the DALI Master controller.
3. PUSH Dimmer Mode
While connected to a PUSH AC, the controller will be in Push Dimmer mode, the operations in Push Dimmer mode are as follows:
3.1. Press the button to turn on/off.
3.2. Press and hold the button to increase or decrease the light intensity to the desired level and release it, then repeat the operation to adjust the light intensity in the opposite direction. The dimming range is from 1% to 100%.
3.3. The memory function after power off or power failure allows the device to remember the state before the power was turned off when it turns back on.
4. Triac dimming input
When connected to a Triac dimmer, different Triac dimmers from different suppliers may have different minimum dimming levels below which the controller cannot be dimmed. To dim to 1%, make sure that the dimmer supports a minimum dimming level of 1%.
