LED Strip 12V-DC 50W 10mm single color IP20 (SMD2835 60ch/m) 5 meter roll

✔ Tira LED a 12V de 50W
✔ Disponible en Rojo, Verde o azul
✔ Carrete de 5 metros
✔ 60 chips/metro SMD2835
✔ Distancia de corte 50mm
✔ Grado de protección IP20
✔ Ancho del PCB: 10 mm
✔ Autoadhesiva 3M
✔ Flexible, de alto brillo y luminosidad
✔ Requiere de fuente de alimentación (no incluida)

The LED strip is an element that integrates into your projects with minimal visual impact, creating indirect and diffuse lighting that highlights architectural features.

The SMD2835 LED strips are low power and low consumption. The average consumption is estimated at 10 W/m. They can be cut every 50mm, allowing them to be adapted and joined according to the needs of each project.

Installation:

The LED strip comes with 3M self-adhesive tape on the back. Place it on a smooth, non-porous surface, and make sure to clean it beforehand. Being a flexible strip, it can be used on tight curves. The connection to the power supply can be made using connectors or by directly soldering the wire to the power supply.

For a complete LED strip installation, you will need a controller, a power supply, and optionally, aluminum profiles (surface-mounted or recessed). It is estimated that for 12V LED strips, if you want to run sections longer than 5 meters, you will need to install additional power supplies and signal amplifiers to avoid voltage drops.

Recommended uses:

✔ Highlight architectural contours
✔ Lighting under furniture and shelves, display cases
✔ Hallways, showcases, with indirect lighting