150cm T8 LED Tube 24W with microwave proximity sensor cool white 6000K opal glass
The LED T8 Tube with microwave proximity sensor integrates a presence and proximity sensor, which detects when an object or person is approaching at a distance of approximately 6-10 meters. The microwave sensor activates the tube at its maximum power. Once the area of effect of the LED tube is vacated, after 45 seconds, it reduces its brightness to 30% of the total, providing a courtesy light that is more than sufficient with minimal consumption.
The number of start-ups does not affect the life of the tube, 25,000 hours.
Ideal for parking lots, basements, schools, offices, restrooms, and any other area that requires lighting for extended periods of time.
Considerations to take into account with the T8 LED tube with microwave proximity sensor:
- Do not place any metallic objects in front of the sensor as it may interfere with its operation.
- Ensure a distance of at least 5 meters between tube and tube, as interference may occur between them.
Replaces conventional 60 cm fluorescent lights.
- AC input voltage of 230V
- Constant operation in standby mode at 30% of its power
- Microwave sensor range: 6-10 meters
- High power factor of up to 0.98
- Wide opening angle (180º)
- Opal cover that does not produce glare
- Short circuit and overheating protection
- Includes starter bridge
Installation on ferromagnetic ballasts:
STEP 1: Turn off the main electrical panel and ensure that no electrical current is present.
STEP 2: Remove the old tube and then the starter.
STEP 3: Install the new LED starter bridge (included with each tube).
STEP 4: Remove the capacitor (to prevent voltage spikes)
STEP 5: Install the new LED tube.
Installation in electronic ballasts:
STEP 1: Turn off the main electrical panel and ensure that no electrical current is present.
STEP 2: Remove the old tube (in this case, there is no starter, as it is integrated within the electronic ballast).
STEP 3: Disconnect the wires that enter the electronic ballast (there is no need to remove it, just disconnect it electrically).
STEP 4: Choose one of the 2 tube holders to connect your 2 wires directly to the electrical network.
STEP 5: We recommend labeling the socket where the connection has been made to facilitate the installation of the LED tube.
- If the installation contains a capacitor bank, consult your specialized technician.
