LED Strip 12V-DC 72W 10mm multicolor RGB IP20 (SMD505050 60ch/m) 5 meters Roll

12V-DC 72W LED Strip (300 SMD 5050 Chips), 5 Meter Roll, IP20, 120º Angle, RGB, Cut Every 5cm

• Multicolor RGB

• 12V LED strip at 72W

• 5 meter reel

• 60 chips per meter SMD5050

• Cut-off distance 50mm

• IP20 protection rating

• PCB Width: 10 mm

• 3M Adhesive

• Flexible, high brightness and luminosity

• Requires a power supply (not included)

The LED strip is an element that integrates into your projects with minimal visual impact, creating indirect and diffuse lighting that highlights architectural elements.

The SMD5050 LED strips are medium/high power and low consumption. An average consumption of 14.4 W/m is estimated. They can be cut every 50mm, allowing them to be adapted and spliced according to the needs of each project.

Installation:

The LED strip comes with 3M self-adhesive tape on the back. Place it on a smooth, non-porous surface, and make sure to clean it beforehand. Being a flexible strip, it can be used on tight curves. The mounting to the power supply can be done using connectors or by directly soldering the wire to the power supply.

For a complete LED strip installation, you will need a controller, a power supply, and optionally, aluminum profiles (surface-mounted or recessed). It is estimated that for 12V LED strips, if you want to run lengths of more than 5 meters, you will need to install additional power supplies and signal amplifiers to avoid voltage drops.

Recommended uses:

• Highlight architectural outlines

• Under-cabinet and shelf lighting, display cases

• Hallways, display cases, with indirect lighting