60cm T8 LED Tube 9W with microwave proximity sensor cool white 6000K opal glass
The T8 LED Tube with Microwave Proximity Sensor integrates a presence and proximity sensor, which detects when an object or person approaches within approximately 6-10 meters. The microwave sensor activates the tube at maximum power. Once the area of action of the LED Tube is left, after 45 seconds, it reduces its brightness to 30% of the total, providing a courtesy light that is more than sufficient with minimal consumption.
The number of startups has no effect on the lifespan of the tube, 25,000 hours.
Ideal for parking lots, basements, schools, offices, bathrooms, and any other area that needs lighting for extended periods of time.
Considerations to take into account with the LED T8 tube with microwave proximity sensor:
- Do not place any metal objects in front of the sensor as it may interfere with its operation.
- Ensure a distance of at least 5 meters between tube and tube, as interference may occur between them.
REPLACE CONVENTIONAL 60 CM FLUORESCENTS.
- 230V AC input voltage
- Constant operation in standby mode at 30% of its power
- Microwave sensor range: 6-10 meters
- High power factor of up to 0.98
- Wide opening angle (180º)
- Opal cover that does not produce glare
- Short circuit and overheating protection
- Includes starter bridge
INSTALLATION ON FERROMAGNETIC BALLASTS:
STEP 1: Turn off the power from the main electrical panel and ensure that there is no electrical current.
STEP 2: Remove the old tube and then the starter.
STEP 3: Install the new LED starter bridge (included with each tube).
STEP 4: Remove the capacitor (to avoid overvoltages).
STEP 5: Install the new LED tube.
INSTALLATION IN ELECTRONIC BALLASTS:
STEP 1: Turn off the power from the main electrical panel and ensure that there is no electrical current.
STEP 2: Remove the old tube (in this case, there is no starter, as it is integrated within the electronic ballast).
STEP 3: Disconnect the wires that go to the electronic ballast (there's no need to remove it, just disconnect it electrically).
STEP 4: Choose one of the 2 tube holders to connect your 2 wires directly to the power supply.
STEP 5: We recommend marking the lamp holder where the connection has been made to facilitate the installation of the LED tube.
- IF THE INSTALLATION CONTAINS A CAPACITOR BANK, CONSULT YOUR SPECIALIZED TECHNICIAN.
